Configuring a Static IP address on the DM300M-DM400M

Follow the steps below to configure a static IP address on your device.

1. Press Options.
2. Press Page Down twice.
3. Select Data Centre Options.
4. Press Page Down.
5. Select Network Settings.
6. Select Get IP.
7. Select Specify Address Manually.
8. Select IP, then press C to clear the existing entry. Key in your static IP address. Press Enter or Accept to confirm the new setting.
   Important: If one or more sections contain less than 3 digits, use zeros to fill. e.g. 192.168.1.25 should be entered as 192.168.001.025.
9. Select Subnet Mask/Subnet, then press C to clear the existing entry. Key in your subnet mask settings in the same way as the IP address. Press Enter or Accept to confirm.
10. Select Default Gateway/ Gateway, then press C to clear the existing entry. Key in your default gateway in the same way as the IP address above. Press Enter or Accept to confirm.
11. If requested, press Enter again to confirm the settings.
12. Press Home to exit the setup menu.